Chevron With Border
I dont know if you guys know how to make one but here is a run down of how you do a normal one.http://www.youtube.com/watch?v=-8FsXFWZh7I
You tube video for you.
I made one with a white border. Unfortunatly I did not take pictures of how to do this. Yea Im sorry. But if you know how to make a normal one. I used 12 colors in all for the one I am showing
1 red
1 orange
2 yellows
1 green
2 blues
2 purples
1 white
I used about 20 strings in all for this bracelet total
2 red
2 orange
4 yellows
2 green
4 blues
4 purples
2 whites
1- Tie or make a loop to start off the bracelet. Get the colors in order. I did a rainbow so mine are in that order. I take the white string and make a forward knot on the red string then made a backwards knot. This ensures that the white stays on the outside.
2- I then made two forward knots with the red on the next string then I keep going until I am in the middle.
3- For the other side I did a backwards knot then a forwards knot on the red to make sure that white stays in the middle.
4- last step is I tie them in the middle and start the next row. and continue until desired length.
I am sorry I do not have any pictures I will put up pictures for this bracelet. It might not be the same colors but it will show you how to do it. Again I am sorry and Hope you like the tutorial :D!
Editors
The original author of this tutorial is DesiCuppycakes but it was also edited by gracebri, RockePloeger, Foz, apprentice13 and Alicat.
Uploaded photos (see all 9)
Comments