Square Knot with Beads
Here is how you make a square knot with beads. You will need 4 strings ( all the same color looks best) Take the two strings on the outside to the side and the two in the middle together and tape them down to your work area. Let’s get started!Here is what it looks like.
THE SQUARE KNOT
Step 1: Take the string to the right and put it under the strings in the middle and over the string on the left. Make sure you make a loop like a forward or backward knot.
Step 2: Take the string on the left and put it over the strings in the middle and through the loop.
THE BEADS
Get your beads that you’re using. Pick one to start out with.
Step 3: Take the tape off of the two strands in the middle but keep them together. Take your bead and put it on the two strands in the middle.
Step 4: Take the three strings closest to the right and set up the strings where they fall like the two on the outside and the one in the middle. Then repeat steps 1 – 2. There is one string left over so don’t get confused.
Step 5: Repeat step 4 only using the three strings closest to the left. The last string to the right for the right side will be used again so don't get confused.
If the bracelet isn’t long enough for your wrist, repeat step 1 – 5 until it’s long enough. for your wrist. I hope this tutorial helps! Please comment on it and tell me what I can do better! I hope the picture helps you explain the sqare knot better!
~ superc
Editors
The original author of this tutorial is superc but it was also edited by Stefan, Sareana, Kestrel, k_marie, rueeverdeen, BFF66 and kleinevos.
Uploaded photos (see all 384)
Comments