(( Bracelets )) Loop / Unfinished Knot Bracelet
Table of contents |
---|
1 - Materials 2 - Step by Step 2.0 - Step 1 2.1 - Step 2 2.2 - Step 3 2.3 - Step 4 2.4 - Step 5 2.5 - Step 6 2.6 - Step 7 2.7 - Step 8 2.8 - Step 9 |
Materials
4 strings, all different colours, about 60 inches (150 cm) long, fold-over and make an over hand knot. Anchor it, in the method you usually use. Set up symmetrically.
Step by Step
Step 1
Make 4 chevrons.
Step 2
Make a backwards knot, but stop about 1/2 an inch from the top.
Then make another backwards knot and go all the way to the top.
You have make a loop!
Step 3
Make 2 backwards knots.
Step 4
Repeat steps 2-3, 3 more times.
Step 5
Make a forwards knot, but stop about 1/2 an inch from the top, then make another backward knot and go all the way to the top. You have made a loop.
Step 6
Make 2 forward knots.
Step 7
Repeat steps 5-6, 3 more times.
Step 8
Connect the two sides using the middle strings, and make a forward knot. It is okay since they are the same colour.
Step 9
Repeat steps 2-8 until it is at desired lenght, if wanted finish with 4 chevrons. Then do an overhand knot to finish.
Editors
The original author of this tutorial is milbug but it was also edited by Kestrel, Jeckle, Foz, ririttt and Alicat.
Comments