(( Bracelets )) Twist Knot Bracelet
| Table of contents |
|---|
| 1 - Materials and Set Up 2 - Step by Step 2.0 - Step 1 2.1 - Step 2 2.2 - Step 3 2 - Video |
Materials and Set Up
Cut 2 long strings each a different color.(fingertip to fingertip length) Fold them in half together and tie a knot so there's a loop. I recomend using oppisite colors. They're more noticeable, then say red and orange.
Seperate the strings so colors 1(A) and 2(B) are alternating. ABAB.
Step by Step
Step 1
Take the outside A and B and put them to the sides. In the middle there should be the middle A and B. They are going to act as 1 string.You must keep the middle strings taunt. I hold them in my mouth, but you can also use tape.
Step 2
Take the Right string(outside B) and make a"4" like you start a bw knot. Then take the Left (outside A) and Bring it over far B. This is important because if you dont it will get messed up. Bring B under middle A and B, and through outside B's loop.
Step 3
Your strings should now be in this order: B AB A. keep repeating steps 2-3. After a few knots the strings will start to twist around the braclet. Simply spin them around it so they dont twist anymore. After some time check to see if there are 2 ridges going around the bracelet. If there are, then Congrats!
Hope the directions were clear enough.
Video
Editors
The original author of this tutorial is Nessy .
Moderator comments Show comments