(( How to... )) Safety Pin - Easy way to start bracelets.

Table of contents
1 - Introduction 2 - Step by Step 2.0 - Step 1 2.1 - Step 2 2.2 - Step 3 2.3 - Step 4

Introduction

Starting bracelets can be difficult because strings are not in the correct order, even if you use the tape-down method.

Take a safety pin (paperclips work too) and use the lark-head knot to attach your strings on the pin.

Larks head knot looks just like this:

Tie on your strings in the desired set-up.

Secure the pin on a binder/clipboard with a clasp.

Begin tying your bracelet.

If you make a loop at the END of your bracelet, you can put the loop on the pin, and then are able to take the bracelet on and off.

The original author of this tutorial is kallum .

There is no photo for this tutorial yet. Click here to upload photos of your work!