another question
by stargirl13 |
|
---|---|
|
when you guys make this rather large bracelets, what happens if you run out of string, how do you guys go about adding more? |
RE: another question
by kristiiinejoy |
|
|
i hate getting this problem. but im not sure how you can lengthen the string. try knotting them together. just make sure that the knot is small enough not to really notice. hopefully this helps. ? |
RE: another question
by Tzonki |
|
|
i wont reccomend knotting them together because the knot will look really bad, i tried it
|
RE: another question
by wojo |
|
|
wat i do is take more string and knot it on the end of wat you have leave the extra string on when you tie and then depending if the knot comes apart close to the top and once i am done with the bracelet i will cut off the string ends that you see in the bracelet hope this helps
|
RE: another question
by Strudle_Puff |
|
|
i knot it but it comes out looking a bit odd :/ |
RE: another question
by wojo |
|
|
yes it does a little depending where you put it
|
RE: another question
by emm97 |
|
|
what i do is i take another string and just start using it (keep going with the pattern) then when i am finished with the bracelet i cut the string that dangling halfway through the bracelet. but its ok to cut it. because the knots ahead of it are securing it |
RE: another question
by Hantho1235 |
|
|
That's an interesting idea with just using the string, but not knotting it in, that would probably be very helpful, if it works! Thanks(: |
Advertisement | |
$1936was donated |